Karaoke Forums

The mixer i have is a yamaha emx68s:

Features
6-channel stereo design

2 switchable 400-Watt (4 ohm) amplifiers

Built-in limiter to prevent damage from feedback or overload

Channels 1-4 have balanced XLR connectors with switchable pads and phantom power, plus balanced 1/4-in. jacks

Inputs 5 and 6 each include 2 unbalanced inputs

All Channel Mute switch

All channels contain 3-band EQ, plus independent monitor and effects sends

RCA connectors with separate level control for a tape recorder or a CD player are also conveniently located on the front panel

2 flexible 7-band graphic EQs (stereo for mains, mono for monitors) provide feedback control and signal shaping

Built-in digital effectsÖbased on the popular Yamaha SPX effects processors

I was looking at these speakers...

peavey PR 15
2-way sound reinforcement enclosure
400 watts program, 800 watts peak
freq. range : 49hrz to 21 khz
50 oz mag.
One 15 inch premium, 2 3/8 inch voice coil woofer
RX14™ compression driver with a 1.4 inch titanium diaphragm 1 inch exit
90 x 40 degree constant directivity horn
Tweeter protection
Heavy-duty crossover
Lightweight molded polypropylene enclosure


Any advice on how these babies would take that mixer? If i'm way off here, anybody know of any good speakers that wouldn't make me broke for this mixer?
Thanks again...

What is you budget?

I would highly reccomend the pro quality Carvin  1584s.   The are an incredible sounding 3 way and you willl not be dissappointed.  The cabinets are built great and the sound quality rivals, in my opinion surpasses the mid range priced JBLs.  I just got mine and they blow away the Eons I was using.  I use my setup for live music and DJ/KJ.  I can here a differnce with all three.

http://www.carvin.com/products/single.p ... 84&CID=CLB

Best Regards,
Bob